Extron electronics SMP 300 Series User Manual page 95

Set both an administrator level password and a user level password — This
•
allows administrators to log in and manage all aspects of the SMP 300 Series. Users
can log in to use just the AV Controls panel and the Recording Controls page.
1 1 1
2 2 2
4 4 4
5 5 5
Figure 65. Password Panel
To set passwords:
1.
Enter a desired password, at least four characters long, into the Administrator
Password field (see figure 65,
• Passwords must consist of any readable characters, up to 128 characters.
Passwords cannot contain a single space or the "pipe" ( | ) character.
•
• Passwords are case-sensitive.
2. Enter the same password into the Confirm Password field (
Administrator Password field. Once a password is entered, the fields in the Login
ID: user section are accessible.
3.
If no user password is set, click Save (
To set a user password, complete steps 4 through 6.
4. To set a user level password, type a desired password into the User Password field
( ) in the Login ID: user panel.
4
5. Type the same password into the Confirm Password field (
User Password field.
6. Click Save ( ). Both the administrator and user passwords are saved.
3
Clearing Passwords
To remove (clear) a password, click Clear (
password and click Save (
3
NOTE: When the administrator password is cleared, the user password is also cleared.
3 3 3
6 6 6
) in the Login ID: admin panel.
1
) in the upper right of the Password panel.
3
) corresponding to the administrator or user
6
) to remove.
SMP 300 Series • Web-Based User Interface
) directly below the
2
) directly below the
5
87