Extron electronics SMP 300 Series User Manual page 26

ATTENTION:
• The length of the exposed wires in the stripping process is important. The
ideal length is 3/16 inch (5 mm). If longer, the exposed wires may touch,
causing a short circuit between them. If shorter, the wires can be easily pulled
out even if tightly fastened by the captive screws.
La longueur des câbles exposés est importante lorsque l'on entreprend de
•
les dénuder. La longueur idéale est de 5 mm (3/16 inches). S'ils sont trop
longs, les câbles exposés pourraient se toucher et provoquer un court circuit.
S'ils sont trop courts, ils pourraient sortir, même s'ils sont attachés par les vis
captives.
• Do not tin the wires. Tinned wires are not as secure in the captive screw
terminals and could pull out.
• Ne pas étamer les câbles. Les câbles étamés ne sont pas aussi bien fixés
dans les terminaisons des à vis captives et pourraient sortir.
HDMI preview output — Connect an HDMI (or DVI with suitable adapter) display
N
device to this HDMI output (see
keyboard and mouse, the preview output can be switched between a preview of the
recorded content and an internal browser client.
Analog audio output — Connect a balanced or unbalanced stereo line level audio
O
device to this 5-pole 3.5 mm captive screw port (see
information) for select audio output.
The audio output depends both on the input selection and if the embedded audio or
analog audio is selected for that input (see
is selected from channel A, channel B, or a mix of both channel A and channel B. For
the SMP 352 and SMP 351 with LinkLicense, with dual mono enabled, audio output
is selected from channel B dual mono or a mix of both channel A and channel B dual
mono.
NOTE: The default audio channel is channel A and channel B. When dual mode is
enabled, the default output is channel A and channel B dual mono.
figure 4 on page 15). Using an attached USB
figure 6
Audio Select on page 43). Audio output
SMP 300 Series • Installation
on page 17 for wiring
18