Layout Presets (For Composite Mode Only) - Extron electronics SMP 300 Series User Manual

Layout Presets (For Composite Mode Only)

n
CHANNEL A
1 2
CHANNEL B
3 4 5
AGE
CONFIG
A A A B B B C C C
Menu display — Displays configuration menus and status information. Use the MENU
G
and NEXT buttons (see
the menu. During normal operation, a default display cycle is presented (see
Procedure on page 25). If there is an active alarm (see
listed instead.
Menu navigation (MENU and NEXT) — Lights amber (unless menu lockout is
H
enabled). Press to access and navigate the configuration and control menus and
submenus.
NOTE: The menu button blinks red when there is an active alarm (see Alarms).
• MENU — Use this button to enter and move through the main menu system.
• NEXT — Use this button to step through the submenus of the selected menu.
Adjust knobs (left [ and right {) — Rotate these controls to scroll through menus
I
and to make adjustments within a menu or submenu.
NOTE: The buttons and controls on the SMP 300 Series can be locked so that
configuration using the front panel is not possible (see
(Executive Modes)
I/O display — A stack of four green LEDs that correspond to the four digital I/O
J
connections on the rear panel (see
on or off status of the corresponding ports which can be configured as digital input or
digital output (see
Layout presets define which inputs are selected and where they are placed on the output
screen. There are 12 preconfigured and 4 user presets for custom layout configurations.
AUDIO
L R LAY OU T
P R E SE T
MARK SWAP SWA P
D D D E E E F F F
Figure 9. Front Panel Layout Preset and Swap
The two input channels, A and B, are determined by direct selection from the front panel.
To select 1 of the 12 preconfigured layout presets:
1. Select input 1 or 2 for channel A and input 3, 4, or 5 for channel B (see figure 4).
2. Press LAYOUT PRESET (see figure 9,
( ).
G
3. Use either ADJUST knob (
name appears on the output display, stop.
figure 8 on page 21,
on page 49).
figure 4
Digital I/O Configurator
ADJUST
ME NU
NE XT NE XT
G G G H H H I I I
) to open the menu on the front panel display
F
) to cycle through the presets. When the desired layout
I
) and ADJUST knobs (
H
Alarms on page 49), it is
Front Panel Lockout
on page 15). Each LED indicates the
on page 104).
SMP 351
Streaming Media Processor
I/O
1
2
3
4
J J J
SMP 300 Series • Front Panel Operations
) to navigate
I
Power Up
23