Extron electronics SMP 300 Series User Manual page 99

4. To save recordings to two locations at once (dual recording mode):
NOTE: Secondary storage mode is not available and cannot be selected if dual
channel encoding mode is active.
a. Select (check) the Secondary Recording Enabled checkbox (see figure 70,
Figure 70. Recording Media Selection - Enable Dual Recording
The selection in the Recording Destination: field changes to Internal
•
Drive ( ). This cannot be changed in dual recording mode. The recording is
2
always stored to the internal drive.
The Secondary Recording Destination: drop-down list is enabled (
•
b. Select an option (Auto, Front USB, Rear USB, or RCP USB) from the Secondary
Recording Destination: drop-down list.
This designates which storage drive (if one is connected at that location and it
•
has been enabled in the Record Destination pane) is used to store a second
copy of the recording.
• If Auto is selected, the secondary recording destination is based upon the
selections made in
secondary recording destination are enabled (see figure 69,
Optionally, limit users to the storage drive location selected in step 2 or the Secondary
5.
Recording Destination specified in step 4 (without the ability to change locations).
To do so, select (check) the Record Destination Limiter checkbox (
NOTE: If the Record Destination Limiter checkbox is selected and the
setting has been saved by clicking the Save button within the Recording Media
Selection panel, destination settings cannot be changed and secondary storage
mode cannot be enabled or disabled until the Record Destination Limiter is
disabled and that change is saved.
Once the Record Destination Limiter has been disabled, make changes to
the other settings and save the changes.
Setting the Recording File Limits
Recording files can be limited (portions of long recordings) to a specific size. If this feature is
enabled (default), each time a recording file reaches the specified size, the file is saved and
the SMP creates a new file (up to the specified size) for the next portion of the recording,
and so on until the recording event ends or the SMP runs out of storage space.
step 2 on page 90. Ensure Internal and the desired
SMP 300 Series • Web-Based User Interface
).
1
).
3
on page 90).
3
).
4
91