Extron electronics SMP 300 Series User Manual page 70

If the unit is NOT set to limit the recording destination, recording destination options are
•
as follows:
• auto — The recording is saved to the first available storage location that is not full.
The priority is front USB port, rear USB port, internal memory. If a USB drive has
more than one logical volume, only the volume with the largest free space for that
port in the Recording Destination drop-down list is used to store content.
To record to another volume on the device, the target location must be manually
select rather than using the auto option.
internal — The recording is saved in the internal memory of the SMP.
•
• external-usbfront/usbrear/VOLUME2/, usbrear/VOLUME1/, usbrear/NEW_
VOLUME, usbrcp/volume3, and so forth — The recording is stored to the indicated
external USB drive and volume (using whatever volume name is on that drive)
connected to the front panel or rear panel USB storage port on the SMP.
If the unit is set to limit the recording destination, you cannot change the storage
•
location (internal, front USB, rear USB, RCP USB). However, if the unit is set to store
recordings to one of the USB ports, and if the connected drive contains more than one
volume, you can select a volume from the Recording Destination drop-down list.
If the unit is set for secondary storage mode, the file is saved to two storage drives
simultaneously. In dual recording mode, the recording is always saved to the internal drive
as the primary storage location; only the secondary location is configurable.
Figure 38. Ad hoc Recording, Secondary Recording Destination Selection
Select the secondary storage location from the drop-down list (see figure 38).
• If the unit is set to restricted mode, you can select only from front panel USB drives
or from rear panel USB drives, depending on whether the front or the rear option is
selected in the system settings. If the unit is set to use a front panel USB drive for
the secondary storage location but a drive is connected to the rear panel USB port
instead of the front panel port, the Secondary Recording Location: drop-down
list displays n/a (not available or not applicable) as the only option.
• If the unit is NOT set for restricted mode, you can select any available USB drive
and volume.
• If no USB drive is attached to a particular port, the option for that port is either not
shown at all or is shown as n/a.
SMP 300 Series • Web-Based User Interface 62