Table of Contents
Advertisement
MAINTENANCE
MAINTENANCE PROCEDURE
INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250
HOURS)
As the 1st maintenance of a new machine, perform the following maintenance after operating initial 250 hours.
•
Replacement of power train oil filter element (500 hours maintenance)
•
Replacement of power train case oil and cleaning of power train pump strainer and scavenging pump
strainer (1000 hours maintenance)
•
Replacement of final drive case oil (1000 hours maintenance)
•
Replacement of hydraulic oil, replacement of hydraulic oil filter element (2000 hours maintenance)
For the maintenance method, see 500 hours maintenance, 1000 hours maintenance, and 2000 hours mainte-
nance.
WHEN REQUIRED
METHOD FOR CHECKING, CLEANING AND REPLACING AIR CLEANER
•
If inspection, cleaning, or maintenance is performed while the engine is running, dust enters into
the engine and damages it. Be sure to stop the engine before performing these works.
•
When using compressed air, there is a danger that dirt may scatter and cause personal injury. Al-
ways wear protective equipment such as protective eyeglasses and dust mask.
•
When working in high places or where the foothold is poor, be careful not to fall because of the re-
action when pulling out the element.
METHOD OF CHECKING
NOTICE
Do not clean the element before the air cleaner clogging caution lamp lights up or the yellow piston of
the dust indicator laps over the peripheral red zone.
If the element is cleaned before the above, the air cleaner cannot display its normal performance and
the cleaning effect decreases.
In addition, during the cleaning operation, more dirt stuck to the element will fall inside the inner ele-
ment.
In the following cases, clean or replace the air cleaner element.
•
When the air cleaner clogging caution lamp lights up
k
k
WARNING
MAINTENANCE PROCEDURE
4-15
Advertisement
Chapters
Table of Contents
