Table of Contents
Advertisement
OPERATION
NOTICE
This method of lifting applies to the standard specification machine.
The method of lifting differs depending on the attachments and options installed.
For details of the procedure for machines that are not the standard specification, consult your Komatsu
distributor.
For the weight, see "SPECIFICATIONS (5-2)".
When lifting the machine, stop it on a level place, then lift it as follows.
1.
Stop the engine.
2.
Set the parking brake lever securely to LOCK position (L).
3.
Set the work equipment lock lever securely to LOCK posi-
tion (L).
4.
Install wire ropes and slings matching to the weight of the
machine as shown in the figure (A).
NOTICE
•
Use protectors, etc. so that the wire ropes will not
be broken at sharp edges or narrow places.
•
When using a spreader beam, select an ample
width to prevent contact with the machine.
5.
Just before slinging the machine, lift it off the ground by
100 to 200 mm while it is being set.
6.
Check that the wire ropes are free of looseness and the
machine is kept on a level state.
7.
Sling the machine slowly.
TRANSPORTATION
3-219
Advertisement
Chapters
Table of Contents
