Table of Contents
Advertisement
OPERATION
METHOD FOR CHECKING BACKUP ALARM OPERATION STATUS
1.
Turn the starting switch to ON position (B).
2.
Set the parking brake lever to LOCK position (L).
3.
Set the joystick (steering, directional and gear shift lever)
in REVERSE position (R).
The alarm must sound immediately at this time.
The alarm keeps sounding until the joystick (steering, di-
rectional and gear shift lever) is set to NEUTRAL position
(N) or FORWARD position (F).
4.
After checking the alarm operation, return the joystick
(steering, directional and gear shift lever) to NEUTRAL po-
sition (N) immediately.
5.
Return the starting switch to OFF position (A).
METHOD FOR ADJUSTING
METHOD FOR ADJUSTING OPERATOR'S SEAT
•
When adjusting the position of the operator's seat, always set the work equipment lock lever and
parking brake lever to LOCK positions to prevent any accidental contact with the control levers.
•
When adjusting the operator's seat, stop the machine at a safe place.
NOTICE
If you adjust the operator's seat while parts, tools, empty cans, etc. are left around, the peripheral parts
and operator's seat may be damaged.
Before adjusting the operator's seat, check that there is no part, etc. around it.
•
Always adjust the operator's seat before starting each operation or when the operators change shift.
•
When adjusting the seat, put your back against the backrest and adjust to a position where the brake pedal
can be fully depressed.
MACHINE OPERATIONS AND CONTROLS
k
k
WARNING
3-145
Advertisement
Chapters
Table of Contents
