Table of Contents
Advertisement
OPERATION
2.
Pull out dipstick (G) and wipe off the oil with a cloth.
3.
Insert dipstick (G) fully into the dipstick pipe and pull it out.
4.
Check if the oil is sticking up to between marks H and L on
dipstick (G).
•
When the oil level is between marks H and L, it is
proper.
•
If the oil level is below mark L, add oil through oil filler
port (F).
•
If the oil level is higher than mark H, decrease it to a
proper level according to the following procedure.
1)
Remove cover (1) on the lower rear side of the ma-
chine.
2)
Place an oil container to catch oil under drain plug (P).
3)
Loosen drain plug (P) to drain excessive oil.
4)
Check the oil level again.
5.
After the oil is adjusted to a proper level, insert dipstick (G)
fully into the dipstick pipe again.
6.
Close the small cover at the top of the right side of the ma-
chine.
METHOD FOR CHECKING DUST INDICATOR
1.
Open the engine side cover on the rear left side of the machine and cover (1).
2.
Check if the inside yellow piston of dust indicator (2) is lap-
ped over the peripheral red zone.
3.
If the yellow piston is lapped over the red zone, clean or
replace the element immediately.
For the cleaning method of the element, see "METHOD
FOR CHECKING, CLEANING AND REPLACING AIR
CLEANER (4-15)".
MACHINE OPERATIONS AND CONTROLS
3-137
Advertisement
Chapters
Table of Contents
