Table of Contents
Advertisement
MAINTENANCE PROCEDURE
CHECKS BEFORE STARTING
For the following items, see OPERATION, "METHOD FOR CHECKING BEFORE STARTING (3-132)".
•
Method for draining water and sediment from fuel tank
•
Method for checking water separator, draining water and sediment
•
Method for checking oil level in hydraulic tank, adding oil
•
Method for checking coolant level, adding coolant
•
Method for checking oil level in engine oil pan, adding oil
•
Method for checking oil level in power train case and adding oil
•
Method for checking dust indicator
•
Method for checking brake pedal travel
•
Method for checking electric wiring
•
Method for checking fuel level, adding fuel
•
Method for checking DEF level, adding DEF
•
Method for checking lamps operation
•
Method for checking machine monitor
•
Method for removing deposit in engine compartment
•
Method for checking horn operation
•
Method for checking backup alarm operation status
EVERY 250 HOURS MAINTENANCE
METHOD FOR LUBRICATING
METHOD FOR LUBRICATING LIFT CYLINDER SUPPORT SHAFT
1.
Lower the blade until the idler is raised 1 to 2 cm above the ground, and stop the engine.
2.
By using a grease pump, pump in grease through the grease fittings.
3.
Start the engine again, raise the blade 1 to 2 cm above the ground, and stop the engine.
4.
By using a grease pump, pump in grease through the grease fittings again.
5.
After greasing, wipe off any old grease that is pushed out.
(1) Lift cylinder support shaft (2 places)
METHOD FOR LUBRICATING PARTS OTHER THAN LIFT CYLINDER SUPPORT
SHAFT
1.
Lower the blade to the ground and stop the engine.
2.
By using a grease pump, pump in grease through the grease fittings.
3.
After greasing, wipe off any old grease that is pushed out.
4-40
MAINTENANCE
Advertisement
Chapters
Table of Contents
