Komatsu D85EX-18 Operation & Maintenance Manual page 218

Table of Contents

Advertisement

MACHINE OPERATIONS AND CONTROLS
Immediately after starting the engine, avoid sudden starts, sudden acceleration, unnecessary sudden
stops, and sudden changes in direction of the machine.
METHOD FOR ENGINE WARM-UP OPERATION
NOTICE
Do not perform operations or operate the levers sharp-
ly while the hydraulic oil is at low temperature. Always
perform the warm-up operation until the hydraulic oil
temperature caution lamp shows the green display.
Performing the warm-up operation properly will extend
the service life of the machine.
Do not accelerate the engine abruptly until it is
warmed up.
Do not run the engine at low idle or high idle under no
load for more than 20 minutes. This will have an ad-
verse effect on the environment and also on the inter-
nal structure of the turbocharger and engine. If it is
necessary to run the engine at idling, apply a load
from time to time or run at a medium speed.
If the engine oil pressure caution lamp on machine
monitor (2) lights up or the alarm buzzer sounds inter-
mittently, stop the engine and perform inspection.
1.
Turn fuel control dial (1) to a position midway between Low
idle (MIN) and High idle (MAX).
The engine runs at a medium speed.
2.
Run under no load (perform warm-up operation) for ap-
proximately 5 minutes.
3.
After the warm-up operation, check that each gauge and
caution lamp indicate the normal values.
If any problem is found, perform maintenance or repair.
4.
Operate under light load until the engine coolant tempera-
ture gauge on machine monitor (2) indicates green range
(A) to (C).
(A) to (B): Red range
(A) to (C): Green range
(C) to (D): White range
5.
Check for abnormal exhaust gas color, noise, or vibration.
If any abnormality is found, contact your Komatsu distribu-
tor.
REMARK
The cooling fan speed varies according to the following conditions, but it is not abnormal.
The cooling fan speed increases when the hydraulic oil temperature , engine coolant temperature, or power
train oil temperature is high.
If the air-conditioner is running, the cooling fan rotates at a higher speed even if these temperature is low.
3-164
OPERATION

Advertisement

Table of Contents
loading

This manual is also suitable for:

D85px-1822001

Table of Contents