Komatsu D85EX-18 Operation & Maintenance Manual page 206

MACHINE OPERATIONS AND CONTROLS
METHOD FOR ADJUSTING JOYSTICK (STEERING, DIRECTIONAL AND GEAR
SHIFT LEVER) (PCCS LEVER)
After moving case (2) in order to adjust the position of the joystick (steering, directional and gear shift
lever) (PCCS lever), secure lock lever (1) into the notched hole, making sure it is in LOCK position.
If the locking condition is unstable, when the joystick (steering, directional and gear shift lever) is oper-
ated, the machine may move unexpectedly and can cause personal injury or death.
You can move and adjust the joystick (steering, directional and gear shift lever) to 9 steps in the forward/back-
ward range of 90 mm. Adjust to the most suitable position to match the adjustment of the operator's seat.
1.
Pull up lock lever (1) at the rear of case (2) on the left side
of the operator's seat, and set it to FREE position (F).
2.
While pulling up lock lever (1) with one hand, hold the front
part of case (2) with the other hand, and move in the for-
ward and backward directions with both hands.
The joystick (steering, directional and gear shift lever)
moves together with the case.
3.
While moving, set the case to a desirable clicking position,
and release lock lever (1).
Lock lever (1) returns automatically to LOCK position (L).
REMARK
PCCS: Abbreviation for Palm Command Control System
METHOD FOR ADJUSTING ARMREST
The R.H. and L.H. armrests of the operator's seat can be adjusted in height as shown below. After adjusting the
operator's seat, adjust them to proper height.
METHOD FOR ADJUSTING RIGHT ARMREST
R.H. armrest (1) can be adjusted to 20 mm and 40 mm above and 20 mm below the standard height, to 4 steps
in total.
1.
Set lock lever (2) to FREE position (F). (2 places)
2.
Move armrest (1) forward.
3.
Set to a hole at a desirable height.
4.
While holding armrest (1) to the desirable height, set lock
lever (2) to LOCK position. (2 places)
Armrest (1) is fixed.
3-152
k k
WARNING
OPERATION