Figure 79: User Exec Mode Prompt - Allied Telesis AlliedWare Plus x950 Series Installation Manual

Chapter 8: Configuring the Master Switch
142
3. Configure the VT-100 terminal or terminal emulation program as
follows:

Baud rate: 9600 bps
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow controller: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter. You are prompted for a user name and password.
5. Enter the default user name and password. They are "manager" and
"friend" (without the quotes), respectively
Note
User names and passwords are case sensitive.
The local management session starts when the User Exec mode
prompt, shown in Figure 79. is displayed.
awplus>
Figure 79. User Exec Mode Prompt
Note
The User Exec mode is the first level in the command mode
interface. For complete information on the modes and commands,
refer to the Software Reference for AT-x950 Series Switches,
AlliedWare Plus Operating System from www.alliedtelesis.com.
6. Do one of the following:
 To begin configuring the master switch, go to "Configuring the
Master Switch - Part I" on page 145.
 If you have already configured the master switch, go to Chapter 9,
"Configuring Member Switches" on page 155.