Figure 63: User Exec Mode Prompt - Allied Telesis x950 Series Installation Manual

Chapter 8: Verifying and Configuring the Switch
120
3. Configure the VT-100 terminal or terminal emulation program as
follows:
Baud rate: 9600 bps

Data bits: 8

Parity: None

Stop bits: 1

Flow controller: None

Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter. You are prompted for a user name and password.
5. Enter the default user name and password. They are "manager" and
"friend" (without the quotes), respectively
Note
User names and passwords are case sensitive.
The local management session starts when the User Exec mode
prompt, shown in Figure 63. is displayed.
awplus>
Figure 63. User Exec Mode Prompt
Note
The User Exec mode is the first level in the command mode
interface. For complete information on the modes and commands,
refer to the Software Reference for x950 Series Switches,
AlliedWare Plus Operating System from www.alliedtelesis.com.
6. Go to "Verifying the Switch with AlliedWare Plus Commands" on
page 121.