Disabling Vcstack; Figure 52: User Exec Mode Prompt; Figure 53: Show Stack Command - Allied Telesis XS900MX Series Installation Manual

Disabling
VCStack
awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
Operational Status
Stack MAC address
awplus(config)#
To disable the VCStack feature to use the switch as stand-alone unit,
perform the following procedure:
Caution
Disabling the VCStack feature requires resetting the switch. If the
switch is already connected to a live network, some network traffic
may be lost. 
1. When prompted, enter a user name and password to log on the switch.
If this is the initial management session of the switch, enter "manager"
as the user name and "friend" as the password. The user name and
password are case sensitive.
The local management session starts when the User Exec mode
prompt, shown in Figure 52, is displayed.
awplus>
Figure 52. User Exec Mode Prompt
Note
The User Exec mode is the first level in the command mode
interface. For complete information on the modes and commands,
refer to the Software Reference for XS900MX Series Switches,
AlliedWare Plus Operating System from www.alliedtelesis.com/
support.
2. Enter the SHOW STACK command to display the status of the
VCStack feature. Figure 53 is an example of the command.
MAC address
0015:774f:ed30
0015:774f:ed30
Figure 53. SHOW STACK Command
XS900MX Series Installation Guide for Stand-alone Switches
E75A
Priority Status
128 Ready
Standalone Unit
Role
Active Master
83