Installing the Power Cord Retaining Clips
The chassis comes with two power cord retaining clips in the accessory
kit. They are used to prevent the power cords for the AT-SBxPWRSYS2
AC power supply from being accidentally disconnected from the unit. To
install a power cord retaining clip, press in the sides and insert the ends
into the holes above and below the AC connector. Repeat to install the
second power cord retaining clip. Refer to Figure 59.
Figure 59. Installing the Power Cord Retaining Clips
Note
The power cord retaining clips are not used with the AT-
SBxPWRSYS1-80 DC power supply.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
107