Installing The Power Cord Retaining Clips; Figure 52: Installing The Power Cord Retaining Clips - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Installing the Power Cord Retaining Clips

The chassis comes with two power cord retaining clips in its accessory kit.
The clips are used to prevent the power cords for the SBxPWRSYS2 AC
power supply from being accidentally disconnected from the unit. To install
a power cord retaining clip, press in the sides and insert the ends into the
holes above and below the AC connector. Repeat to install the second
power cord retaining clip. Refer to Figure 52.
Figure 52. Installing the Power Cord Retaining Clips
Note
The power cord retaining clips are not required for the
SBxPWRSYS1-80 DC power supply.
After installing the retaining clips, go to Chapter 4, "Powering On the
Chassis" on page 89.
SBx908 GEN2 Installation Guide for Stand-alone Switches
87