Table of Contents
Advertisement
Parameter unit (FR-PU04) setting
2.16.3 PU contrast adjustment (n15
By setting the communication parameter n15 "PU contrast adjustment", you can
adjust the LCD contrast of the parameter unit (FR-PU04). When using the FR-
PU04, adjust the numerical value to any darkness with the
that brightness with the
Parameter
n15 (991)
PU contrast adjustment
The parameter number in parentheses is the one for use with the parameter unit (FR-
PU04).
CAUTION
When using the FR-PU04, you should press the
setting value.
2.16.4 PU main display screen data selection (n16
You can choose the main display screen of the parameter unit (FR-PU04).
Parameter
Name
PU main display
n16 (992)
screen data
selection
The parameter number in parentheses is the one for use with the parameter unit (FR-
PU04).
<Setting>
When "100" is set in n16, the monitor value is different depending on whether the
inverter is at a stop or running.
Output frequency
Output current
Alarm display
REMARKS
During an error, the output frequency at error occurrence appears.
During MRS, the values displayed are the same as during a stop.
♦
Related parameters
⇒
Speed display
Pr. 37 "speed display" (refer to page 79)
of the parameter unit.
WRITE
Factory
Name
Setting
Factory
Setting
0
0
During operation/stop
Output frequency
♦
)
Setting
Range
58
0 to 63 Setting is enabled when Pr. 30 = "1"
WRITE
Setting
Range
0, 100 Setting is enabled when Pr. 30 = "1"
n16
During stop
Set frequency
Output current
Alarm display
150
/
and define
Remarks
to store the PU contrast
)
Remarks
100
During operation
Output frequency
Advertisement
Table of Contents
