DAF 95XF Series Manual page 84

INTERNAL CAB COMPONENTS
Removal and installation
4.23 REMOVAL AND INSTALLATION, ELECTRICALLY OPERATED WINDOW
MECHANISM
Removing electrically operated window
mechanism
1. Remove the door panel.
2. Remove the foil (A).
2
3. Lower the glass, remove the attachment
bolts (1) and raise the glass.
4. Detach the electric motor connector.
5. Remove the caps (5), attachment bolts (2)
and (4) and attachment nuts (3).
6. Remove the window mechanism out of the
door through the opening.
Installing electrically operated window
mechanism
1. Fit the window mechanism in the door and
fit the attachment bolts (2) and (4), the
attachment nuts (3) and the caps (5).
2. Connect the electric motor connector up.
3. Lower the glass and fit it to the window
mechanism using attachment bolts (1).
4. Operate the window switch and close the
glass almost completely.
Check whether the top edge of the glass is
parallel with the window frame.
Loosen the attachment bolts (1), if
necessary.
Adjust the glass to the correct position and
re-tighten the attachment bolts.
5. Fit the new foil (A).
6. Fit the door panel.
4-28
95XF series
4
2
A
1
2
3
5
K1 01 513
0209