DAF 95XF Series Manual page 176

EXTERNAL CAB COMPONENTS
Removal and installation
Gluing the plastic window
ATTENTION:
- Because a film forms on the beads of glue
(something which has a very negative
impact on the quality of the glue), it should
take no longer than 10 minutes to apply the
beads, glue the surfaces together and fix
them.
- Apply the beads of glue no more than 8
hours after the pre-treatment with primer.
Note:
Open the vehicle windows in order to cushion
shock waves caused by closing the vehicle
doors. Avoid making the vehicle vibrate while
the glue is setting, as this could cause the
4
window to shift out of place.
1. Give the spraying nozzle the shape shown
in the drawing.
2. Apply an 8x12 mm (wxh) bead of glue (see
illustration) in the neck of the window seal.
Use the specified glue for gluing the plastic
window, see "Technical data".
3. Fit the window into the frame and press it
into the bead of glue in such a way that the
window lines up evenly with the outside of
the polyester roof.
4. Immediately after fitting the window, fix it
into place with sturdy tape at a few points to
prevent it from shifting.
4-50
95XF series
12 mm
K1 00 721
12mm
200345
1
8mm
K100238