DAF 95XF Series Manual page 267

1
95XF series
4.10 REMOVAL AND INSTALLATION, BACKREST
Removing backrest
1. Remove the seat squab.
2. Remove the screws (1) from the cover (2)
and remove screw (3) from the mounting
plate.
3. Remove the rubber air hoses (4)
(connection is underneath the seat belt roll
holder) and the electric plug connector (5)
(if applicable).
4. Remove screw (6) and lift the backrest in
the closed position out from the side rails of
the frame.
IPS system
1. Remove the entire seat.
2. Remove the side cover on control side
(without disconnecting the air hoses from
the IPS valve).
3. Remove screw (7) from the seat belt
mounting bracket and screw (8) from the
seat belt roll.
4. Remove the rubber air hoses (4)
(connection is underneath the seat belt roll
holder) and the electric plug connector (5)
(if applicable).
Installing backrest
1. Install the backrest in the closed position
into the frame and secure it to the specified
torque. See "Technical data".
2. Connect the air pipes (4) and the seat
heating connector (5) (if present).
3. Fit the seat belt roll holder and tighten it to
the specified tightening torque, see
"Technical data".
4. Fit the screw (3) in the mounting plate.
5. Fit the cover (2).
6. Fit the seat squab.
0209
Removal and installation
3
6
5
4
SEATS
1
2
8
7
7
K100496
4-7