DAF 95XF Series Manual page 277

1
95XF series
Removing backrest adjuster with Y-section
1. Remove the seat squab.
2. Remove the lumbar support.
3. Remove the side cover.
4. Remove the screws (1) and (2) on control
side and on the opposite side.
5. Remove the lock rings (3) and (11).
6. Lift the spring (6) and pull the control plate
(4) from the axle, after which the rod (5) can
be removed.
7. Loosen the screw (7) of the backrest
adjuster and remove it.
8. Loosen the check nut of the coupling piece
in the centre of the pull rod (10) and divide
the pull rod by loosening the coupling piece.
9. Push the tooth segment assembly from the
bracket (9) until the pull rod (10) can be
removed.
10. Remove the tooth segment (8) combination
together with the bracket (9) from the seat
in downward direction.
Installing backrest adjuster with Y-section
1. Fit the adjuster together with the pull rod
(10) on either side of the seat.
2. Fit the coupling piece of the pull rod (10)
together and tighten the check nut.
3. Insert the screw (7) into the backrest
adjuster.
4. Lift the spring (6) and fit the control plate (4)
onto the axle, after which the rod (5) can be
fitted.
5. Connect the lock rings (3) and (11).
6. Insert the screws (1) and (2) on control side
and on the opposite side.
7. Fit the side cover, the backrest and the seat
squab.
0209
SEATS
Removal and installation
4
3
6
5
11
10
8
9
7
2
K101366
4-17
1
7