DAF 95XF Series Manual page 132

EXTERNAL CAB COMPONENTS
Removal and installation
Installing the drop glass
1. Position the drop glass in the door.
2. Fit the window pillar.
3. Fit the window guide by first fitting the
fastening lip (1) of the window guide in the
recess (2) in the door. Now fit the
attachment bolt (3), but do not tighten it yet.
Slide up the window guide as far as
possible and tighten the attachment bolt (3).
4
4. Fit the rubber seals and squeegee strips.
Make sure that the foil (against the inside of
the inner plate) is pressed against the inside
of the door by the lower squeegee strip. .
5. Secure the drop glass to the window
mechanism, using the attachment bolts (1).
6. Close the drop glass until nearly shut.
Check that the top edge of the window is
parallel to the window frame. If necessary,
loosen the attachment bolts (1) and adjust
the drop glass.
7. Fit new foil on the inside of the door.
8. Install the door panel.
4-6
2
1
1
1
95XF series
3
K1 01 504
K1 01 089
200345