1
95XF series
4.15 REMOVAL AND INSTALLATION, ACCELERATOR PEDAL
Removing accelerator pedal
1.
If applicable, remove the throttle cable from
the accelerator pedal.
2.
Remove the floor mat.
3.
Remove the dashboard panel from above
the accelerator pedal.
4.
Disconnect the accelerator pedal connector,
if applicable.
5.
Remove the attachment bolts (1).
6.
Remove the accelerator pedal from the cab
floor.
Installing accelerator pedal
1.
Check the gasket. Replace the gasket, if
damaged.
2.
Fit the accelerator pedal with gasket on the
cab floor.
3.
Insert the attachment bolts (1). Make sure
that the gasket is positioned just below the
pedal.
4.
If present, fit the connector.
5.
Fit the dashboard panel above the
accelerator pedal.
6.
Place the floor mat.
7.
If present, install the throttle cable to the
accelerator pedal.
0209
INTERNAL CAB COMPONENTS
Removal and installation
2
1
K1 01 448
4-17