DAF 95XF Series Manual page 169

1
95XF series
3. The sanded surface should be cleaned
once again with the specified cleaning
agent, see "Technical data" and allowed to
dry for a minimum of 10 minutes at room
temperature.
4. Check whether the surface is free of
abrasives and other impurities and repeat
the cleaning process if necessary.
5. Next, using a brush apply a single or at
most two thin covering layers of the
specified primer, in accordance with the
supplier's instructions, see "Technical data".
Allow this layer to dry at room temperature
for at least 30 minutes but no longer than 24
hours. Instead of using a brush you may
also use a felt-tip canister with soft felt.
Pre-treating the polyester roof (gel-coated
side)
1. Tape up the edges of the area to be glued
with thin, smooth, adhesive tape. When
taping up the edges of the area to be glued,
keep in mind the drip channel to be applied
later.
2. Clean the places to which glue is to be
applied with a clean, non-pilling cloth
moistened with the specified cleaning
agent, see "Technical data".
3. Lightly sand the surface of the cab front
and polyester roof to be glued with the
specified abrasive, see "Technical data".
4. Clean the sanded surface again with the
specified cleaning agent, see "Technical
data".
5. Allow the cleaned surface to dry for at least
10 minutes at room temperature.
6. Check that the surface to be glued is free of
abrasives and other impurities. If necessary,
repeat the cleaning operation.
7. Using a brush, apply a thin, covering layer
of the specified primer to the surface to be
glued, in accordance with the supplier's
instructions, see "Technical data".
8. Allow the primer layer to dry for at least 30
minutes but no more than 24 hours at room
temperature.
200345
EXTERNAL CAB COMPONENTS
Removal and installation
4
4-43