DAF 95XF Series Manual page 166

EXTERNAL CAB COMPONENTS
Removal and installation
Pre-treatment of cab front, cab drip channel
and polyester roof
Note:
The cab front is understood to mean the edge
above the windscreen.
1. Clean the places to which glue is to be
applied with a clean, non-pilling cloth
moistened with the specified cleaning
agent, see "Technical data".
2. Lightly sand the surface of the cab front
and polyester roof to be glued with the
specified abrasive, see "Technical data".
3. Clean the sanded surface again with the
specified cleaning agent, see "Technical
4 data".
4. Allow the cleaned surface to dry for at least
10 minutes at room temperature.
5. Check that the surface to be glued is free of
abrasives and other impurities. If necessary,
repeat the cleaning operation.
6. Using a brush, apply a thin, covering layer
of the specified primer to the surface of the
cab drip channel and polyester roof to
be glued, in accordance with the supplier's
instructions, see "Technical data".
7. Allow the primer layer to dry for at least 30
minutes but no more than 24 hours at room
temperature.
4-40
1
95XF series
200345