DAF 95XF Series Manual page 207

1
95XF series
16. In the case of a Mechanical Gear Shift
(MGS) control, remove the attachment bolts
at the bottom of the rocker strip.
17. Remove the floor connectors and, if an
E-gas system has been fitted, the E-gas
connector.
18. Remove the connections and wiring of the
automatic grease lubrication system.
19. Remove the rear attachment bolts from the
cab hinges on the left-hand and right-hand
sides.
20. Place wooden blocks onto the rear cab
locks and tilt the cab back.
21. Remove the lifting cylinder at the bottom of
the cab.
22. Remove the door rubbers from the seal on
the left-hand and right-hand sides to install
the lifting yoke.
23. Install the lifting yoke (special tool
DAF no. 1329438) with filling.
24. Hang the cab in the lifting yoke in such a
way as to provide sufficient support for the
cab.
25. Remove the lower attachment points of the
front suspension.
26. Remove the front left and front right
attachment bolts (J) from the cab
silentblocks.
27. Hoist the cab from the chassis; while
hoisting, check whether any cables/pipes
are still connected to the cab. Place the cab
onto a suitable cab stand or onto supports,
protecting the plastic substructure against
any damage.
0209
CAB SUSPENSION
Removal and installation
J
K
H
G
F
K100417
5
4-15