DAF 95XF Series Manual page 282

SEATS
Removal and installation
4.30 REMOVAL AND INSTALLATION, BOWDEN CABLE FOR FIXED SEAT GAS
DAMPER
Removing Bowden cable for fixed seat gas
damper
1. Remove the seat squab.
2. Remove the stops (1) and (2).
3. Remove the Bowden cable by taking it from
the attachment points.
Installing Bowden cable for fixed seat gas
damper
1. After fitting the new Bowden cable, check
the height adjustment. If necessary, adjust
the Bowden cable setting by turning the
screws for the Bowden cable from or
towards one another.
2. Then tighten the Bowden cable using the
check nut.
4.31 REMOVAL AND INSTALLATION, FIXED SEAT GAS DAMPER
Removing fixed seat gas damper
1. Remove the seat squab.
2. Place the seat in its lowest position.
7
3. Remove the stop (1) and Bowden cable (2)
(making sure not to operate the button).
4. Release attachment nuts (3) and (4).
5. Pull the chair upwards, ejecting the gas
spring from its holder.
Installing fixed seat gas damper
1. When installing a new gas spring, tighten
the check nut (5) (in the same position as
the previous gas spring).
2. After fitting, check the height adjustment
and, if necessary, modify the Bowden cable
adjustment.
3. Fit the seat squab.
4-22
1
2
1
3
1
95XF series
K100517
5
2
4
K100518
0209