DAF 95XF Series Manual page 150

EXTERNAL CAB COMPONENTS
Removal and installation
4. Remove the covers (1), locknuts (2) and
washers (3) of the windscreen wiper arm
spindles.
5. Remove the cab grille.
6. Remove the two covers across the wiper
linkage.
7. Turn the crank of the windscreen wiper
arms and remove the nut of the windscreen
wiper motor spindle.
8. Using a plastic hammer, carefully tap the
end of the windscreen wiper motor spindle
and take the crank off the motor spindle.
9. Remove the attachment bolts (4) of the
brackets of the wiper linkage (5).
4
10. Remove the wiper linkage.
Installing the windscreen wiper mechanism
Note:
Apply silicone sealant (all round) to all threaded
holes of the attachment bolts and screws, and to
the attachment bolts and screws fitted in the cab
front. The purpose of this is to prevent water
from penetrating the cab.
1. Fit the wiper linkage and secure it with the
attachment bolts.
2. Fit the washers, locknuts and covers of the
windscreen wiper arm spindles. Tighten the
locknuts to the specified torque. See
"Technical data".
3. Set the windscreen wiper motor in the
neutral position by switching it briefly on and
off, using the control switch.
4. Put the windscreen wiper linkage in the
neutral position and fit the crank with the
attachment nut to the windscreen wiper
motor spindle. Tighten the nut to the
specified tightening torque, see "Technical
data".
4-24
3
2
1
1
95XF series
4
5
K1 01 464
200345