DAF 95XF Series Manual page 148

EXTERNAL CAB COMPONENTS
Removal and installation
Installing the windscreen wiper panel
Note:
Apply silicone sealant (all round) to all threaded
holes of the attachment bolts and screws, and to
the attachment bolts and screws fitted in the cab
front. The purpose of this is to prevent water
from penetrating the cab.
1. Fit the windscreen washer supply hose to
the manifold and fit the windscreen wiper
panel (1) to the cab. Make sure that the
windscreen washer hoses are not kinked
and do not get pinched off when installing
the windscreen wiper panel.
2. Fit the handles (8) with the attachment bolts
(7) and press the caps (6) into the handles.
4
3. Fit the washers (2), locknuts (3) and covers
(4). Tighten the locknuts (3) to the specified
torque. See "Technical data".
4. Fit the attachment bolt (10) and cap (9).
5. Fit the attachment bolts (11) to the ends of
the windscreen wiper panel.
6. Fit the two covers across the linkage of the
windscreen wiper system.
7. Fit the cab grille.
8. Fit the windscreen wiper arms (windscreen
wipers in horizontal position) and the
windscreen wiper hoses.
9. Fit the attachment nuts (5) of the
windscreen wiper arms. Tighten the nuts to
the specified tightening torque, see
"Technical data" and close the covers of the
windscreen wiper arms.
4-22
1
11
10
9
8
7
6
5
4 3 2
1
95XF series
K1 01 461
200345