DAF 95XF Series Manual page 71

1
95XF series
2. Remove the cover plate (1) from the
steering wheel (2).
3. Remove the steering wheel nut (3).
4. Fit the special tool, steering wheel puller
(A), to the steering wheel using its two outer
bolts. Turn the central bolt of the steering
wheel puller until the steering wheel is
released.
Installing steering wheel
1. Check whether the steering gear is still in
the central position using the markings on
the steering box or the steering gear.
2. Fit the steering wheel (2) on the steering
shaft (4) so that the markings on the
steering wheel and the steering shaft (see
the arrows B) "align".
3. Fit the attachment nut (3). Tighten the nut to
the specified tightening torque, see
"Technical data"
4. Fit the cover plate (1).
4.13 REMOVAL AND INSTALLATION, IGNITION LOCK
Removing ignition lock
1. Remove the caps (A) from the steering
column below the steering wheel.
2. Disconnect the connectors (behind the
dashboard).
3. Drill off the head of the security bolt, use a
bit with the same diameter as the hole
where the head falls and remove the
ignition lock.
Installing ignition lock
1. Install the ignition lock.
2. Tighten the security bolts with such a torque
that the heads break off.
3. Fit the covers (A) around the steering
column.
0209
INTERNAL CAB COMPONENTS
Removal and installation
1
2
3
A
B
B
4
A
2
K1 01 144
A
K1 01 154
4-15