DAF 95XF Series Manual page 170

EXTERNAL CAB COMPONENTS
Removal and installation
Gluing the plastic sun visor
ATTENTION:
- Because a film forms on the beads of glue
(something which has a very negative
impact on the quality of the glue), it should
take no longer than 10 minutes to apply the
beads, glue the surfaces together and fix
them.
- Apply the beads of glue no more than 8
hours after the pre-treatment with primer.
See "Technical data" for the type of glue to be
used for gluing the plastic sun visor to the cab.
Give the spraying nozzle the shape shown in the
drawing.
4
Apply 3 triangular beads of glue measuring 8x12
mm (wxh) between the vertical spacer ribs on
the polyester roof (4).
- 1 bead at approx. 10 mm (3) distance from
the bottom of the roof (4),
- 1 bead at approx. 10 mm (1) distance from
where the top of the sun visor (5) is to be
located,
- 1 bead in line with the middle (2) of the sun
visor (5).
Note:
Immediately after applying the beads of glue, fit
the sun visor and press it until the glued seam is
+1
3 mm thick. The sun visor should be
supported in this position for at least 2 hours.
Immediately after gluing, remove any excess
glue with a plastic filling knife or spatula and
smoothen the surface.
4-44
12 mm
10 mm
=
8 mm
=
10 mm
12 mm
1
95XF series
K1 00 721
1
2
3
4
5
K1 01 486
200345