DAF 95XF Series Manual page 278

SEATS
Removal and installation
4.25 REMOVAL AND INSTALLATION, IPS VALVE
Removing IPS valve
1. Remove the seat squab.
2. Remove the side cover on control side.
3. Disconnect the air pipes from the IPS
valve (1).
4. Use a screwdriver to lift the IPS valve (1)
from the cover (2) (the valve may be
damaged slightly in the process).
Installing IPS valve
1. Fit the IPS valve. When fitting, position the
new valve in such a way that the top (3) can
be hooked in and then be pushed down into
the side cover.
2. Connect the air pipes to the IPS valve (1).
3. Install the side cover on control side.
4. Fit the seat squab.
4.26 REMOVAL AND INSTALLATION, AIR BELLOWS
Removing air bellows
7
1. Remove the entire seat.
2. Remove the seat squab.
3. Remove the clamping strip (1) (by
cutting it).
4. Disconnect the air pipe (2) from the
manifold (3).
5. Unscrew the screws (4) and (5) to be able
to remove the air bellows including the air
pipe.
Installing air bellows
1. Install the air bellows (6). In doing so, make
sure that the air bellows is not twisted. If this
is nevertheless the case, loosen screw (4) a
few turns and apply spring action to the
system under pressure; then tighten screw
(4) again while the air bellows is still under
pressure.
2. Tie the pipes together with a clamping strip.
3. Fit the seat squab.
4. Install the entire seat.
4-18
6
2
1
95XF series
2
3
1
K100510
4
3
1
5
K100513
0209