DAF 95XF Series Manual page 280

SEATS
Removal and installation
4.28 REMOVAL AND INSTALLATION, CONTROL UNIT OF HEIGHT CONTROL
VALVE
Removing control unit of height control
valve
1. Remove the seat squab and remove the
dust boot at the front.
2. Lock the system in the highest position.
3. Disconnect the air pipe (1) from the
cylinder (2).
4. Remove the lock ring (3) and pin (4).
5. Loosen the screw (5) slightly and push the
holder (6) of the control discs (7) a little
apart. This makes it possible to pull the
control discs from the adjustment cylinder
(8). The guide plate (9) must remain
attached to the pin (10). Push the ball (11)
back onto the pin (10) if it has come loose.
Installing control unit of height control valve
1. Tighten the screw (5) slightly during
installation.
2. Operate the height adjuster (upwards) and
check whether the cylinder moves freely. If
not, loosen screw (5) slightly.
7
4-20
8
5
6
2
12
7
1
1
95XF series
4
10
11
9
3
K100515
0209