DAF 95XF Series Manual page 208

CAB SUSPENSION
Removal and installation
Installing complete cab
1. Use the lifting beam to place the cab onto
the chassis.
2. Fit the front left and front right attachment
bolts (J) of the silentblocks.
3. Attach the spring elements at the bottom.
4. Remove the lifting yoke.
5. Attach the lifting cylinder to the cab and
tighten the attachment bolts temporarily to a
tightening torque of 125 Nm.
6. Tilt the cab slightly forwards and remove the
wooden blocks on the cab locks. Tilt the cab
back again.
7. Tighten the attachment bolts to the
specified tightening torque, see "Technical
data".
5
8. Tilt the cab forwards.
9. Tighten the upper attachment bolts of the
lifting cylinder to the specified tightening
torque. See "Technical data".
10. Fit the universal joint on the splines of the
steering shaft or steering box. Line up the
groove (A) in the clutch with mark (B) on the
steering shaft or steering box.
Check that the universal joint is
correctly in place on the steering
shaft or steering box so that the
attachment bolt can be put in the
notch (C).
11. Only fit a new attachment bolt with nut to
the universal joint. Tighten the bolt to the
specified tightening torque, see "Technical
data".
4-16
95XF series
J
K
H
G
F
B
A
C
K1 01 353
1
K100417
0209