DAF 95XF Series Manual page 153

1
95XF series
Installing the windscreen wiper motor
1. Check the motor spindle for axial play. If so,
replace the motor. This play will cause
excessive wear to the wiper linkage.
2. Check the windscreen wiper motor sealing
rubber.
3. Install the windscreen wiper motor on the
inside of the bulkhead.
4. Connect the windscreen wiper motor
connector.
5. Fit the attachment bolts on the outside of
the cab.
6. Fit the connectors to the attachment frame
in the cab and connect the connectors.
7. Fit the dashboard panels to the right of the
steering column and the panel underneath
the radio panel.
8. Set the windscreen wiper motor in the
neutral position by switching it briefly on and
off, using the control switch.
9. Put the windscreen wiper arms in the
neutral position (windscreen wipers in
horizontal position).
10. Fit the crank of the windscreen wiper arms
to the windscreen wiper motor spindle and
fit the nut to the motor spindle. Tighten the
nut to the specified tightening torque, see
"Technical data".
11. Operate the windscreen wiper motor and
check the operation of the windscreen wiper
mechanism and the position of the
windscreen wiper arms.
12. Fit the cover over the windscreen wiper
mechanism.
13. Close the cab grille.
200345
EXTERNAL CAB COMPONENTS
Removal and installation
4
4-27