Nortel DMS-100 Series Maintenance Manual page 481

SHELF SLOTS: 1| 2| 3| 4| 5| 6| 7| 8| 9| A| B| C|
A 10|11|11|11|11|11|11|11|11|11|11|11|
B 11|11|11|11|11|11|11|11|11|11|11|11|
C 11|11|11|11|11|11|11|11|11|11|11|11|
D 11|11|11|11|11|11|11|11|11|11|11|11|
Value of 0 = unequipped line, Value of 1 = equipped line
Rt config, All chnl bsy, pWrk trc, aBbt, Set ln config
Disp ln config status, disp ln config Image
cHnl aud, send Cfield msg, Line, sMsr, *
Since we know that the SMS is not receiving the unequipped AB-bit
information from the SLC-96, and the SMS is actually scanning for offhook,
we need to get the line config status to report the line as equipped. Changing
the line config status from the "Set in Config" level of PMDEBUG can do this.
This level asks us for the RT number on which we are working (our RT index
is 1). This PMDEBUG level also prompts us for the line number on which to
take action. From the qlen information, we know that our line number is 1. It
finally prompts us for the value that we want to change to "0" or "1" - we want
to change to equipped so we enter a value of 1.
UP:SMsm> s
rt #:
UP:SMsm> 1
line # (0..95):
UP:SMsm> 1
change to 0 or 1
UP:SMsm> 1
Rt config, All chnl bsy, pWrk trc, aBbt, Set ln config
Disp ln config status, disp ln config Image
cHnl aud, send Cfield msg, Line, sMsr, *
The line config information after the change now indicates that the line is
equipped. It takes up to 1.5 minutes after the change for the CM to be notified
of the new line status. Once this occurs, the line changes back to the IDL state.
UP:SMsm> d 1
XPMTLC0001SMS XPM_PARTITION MICA
Appendix A --17