Nortel DMS-100 Series Maintenance Manual page 24

1-8 Maintenance overview
When you first install the NT7X05 card, the loadfile is invalid. Load the
loadfile with the XPMSTOR parameter. Use the enhanced QUERYPM
command with the new FILES option to view the state of files on the
NT7X05. An example of the QUERYPM command follows.
>QUERYPM FILES
Example of a MAP response:
When loading is necessary, the CM checks to see if the NT7X05 is entered.
If NT7X05 is present, the recovery software loader (RSL) transfers the name
of the desired load file. The RSL indicates if the image or loadfile must be
loaded from the CM to the unified processor (UP). The RSL checks for the
loadfile name on the NT7X05. If the load name test passes, the RSL
restores the image or load to the UP. To avoid delays in loading a good file,
the restore/loading process checks the image/loadfile integrity. Operating
company personnel can use the enhanced QUERYPM command again to
view the state of files on the NT7X05. The following example shows this
procedure:
>QUERYPM FILES
Example of a MAP response:
Unit 0:
Unit 1:
297-8231-550 Standard 09.01 August 1998
Unit 0:
NT7X05 load File: ** Mismatch **
NT7X05 Image File:
CMR LOAD:
Unit 1:
NT7X05 load File: ** Mismatch **
NT7X05 Image File:
CMR LOAD:
NT7X05 load File: ESS05AW
NT7X05 Image File:ESS05AW
CMR LOAD: CMR03A
NT7X05 load File: ESS05AW
NT7X05 Image File:ESS05AW
CMR LOAD: CMR03A
ESS05AW
CMR03A
ESS05AW
CMR03A