Nortel DMS-100 Series Maintenance Manual page 413

Note: Feature AF5006 records cards an XPM implicates and not cards
that the CM generates.
Diagnostics can be grouped together and run as a set of diagnostics or run as
a single test. The following list is a list of defined sets:
the InSv tests
the OOS tests
facility audit tests
mate diagnostics
ROM diagnostics
InSv and OOS tests
The InSv and OOS tests are solicited tests. Any CM requests cause the test
to run. When CM requests to test an XPM unit with the manual
command, manual or system
XPM runs a set of diagnostics. The diagnostics in the set differ according to
the PM type of the XPM, the state of the XPM unit, and the activity of the
XPM unit. If the unit is InSv, the XPM runs a set of InSv diagnostics. If the
unit is OOS, the XPM runs a set of OOS diagnostics.
The results of separate diagnostics return to the CM with a final result for
the complete set. If a card is defective, the system generates a card list. The
system transfers the list to the CM at the termination of the set of tests.
Facility audit
The facility audit is a set of automatic diagnostics the XPM runs. If the
audit encounters problems, the system sends a message to CM. This
message indicates the problem along with a list of defective cards.
Mate diagnostics
If communications are lost with one unit, the mate unit can diagnose the
defective unit. The mate unit sends the results to the CM.
ROM diagnostics
If the XPM is at ROM level, a set of ROM diagnostics occur.
This feature does not record failures or cards that mate and ROM diagnostics
implicate. For each diagnostic, the system generates a card list or log at the
MAP terminal. Diagnostic history does not include card list or diagnostic
failures.
The following table lists and describes diagnostics that this feature supports.
The diagnostics are classified as solicited, audit, or solicited and audit
,
>RTS >SWACT
DMS-100 Family SMS Maintenance Manual XPM10 and up
Trouble isolation and correction 9-49
, or commands, the
>BSY >REX
>TST