Nortel DMS-100 Series Maintenance Manual page 472

A --8 Appendix
line indicated that our line was on node number 235. If we find the entry for
Node 235, we see that it is Internal code number 2 in the table, external code
number 235, and its RCT number is 0. In order to get the RT index number for
this SMS, we must add 1 to the RCT number. Therefore our RT index for the
SLC-96 is 1 (0 + 1) for this SMS.
Node,Port,Spec,H_l_mux,Utr,NX,PRt_ps,Audt,Xlat,Msgnode,ND_hash
,MCh,Cs_map,PS_map,Iu_map,Ring,ST_cd,RCc_ltc.
UP:Prot> *
UP:Chnls> *
LTCUP> *
TIme,TAsk,Load,Xprompt,CHEaptmr,DAtadump,Uspace,Debug,BPMonito
r,Swerr,C++monitor,Ipc,Verreg,Patches,Flq,Msg6x69,UArtimc,Newm
sging,NWmsgtrc,MSGTr,Chnls,CDm,DYnamic,MTc,Rcvrmon,SChnls,CSm,
DS1,CMr,UTr,OMUnsol,DIagnose,IMage,
Audit,MAtediag,CAudit,PRfm,PErcall,Bigfoot,PARaudt,CP,CNd,Trmt
rc,SMsm,SMSS,LTst.
LTCUP> sm
Rt config, All chnl bsy, pWrk trc, aBbt, Set ln config
Disp ln config status, disp ln config Image
cHnl aud, send Cfield msg, Line, sMsr, *
Now we dump the config status. This information is used to determine if the
SLS thinks the line is unequipped or equipped. We are looking at the first two
lines on the SLC-96. They show up in the location for Shelf A, Slot 1. Each
line has a value of 1, which means equipped. This is the expected state for a
line in the IDL state.
UP:SMsm> d 1
SHELF
A
B
C
D
Value of 0 = unequipped line, Value of 1 = equipped line
Rt config, All chnl bsy, pWrk trc, aBbt, Set ln config
Disp ln config status, disp ln config Image
cHnl aud, send Cfield msg, Line, sMsr, *
UP:SMsm>
Now we check what the SMS is receiving from the SLC-96. We do this by
reading the AB-bit information from the SMS timeswitch. We know from the
data dumped earlier that the A shelf of this SLC-96 is connected to SMS 0 link
OPEN WRITING XPMTLC0001SMS.AA02 2000/04/13 11:31:50
SLOTS: 1| 2| 3| 4| 5| 6| 7| 8| 9| A| B| C|
11|11|11|11|11|11|11|11|11|11|11|11|
11|11|11|11|11|11|11|11|11|11|11|11|
11|11|11|11|11|11|11|11|11|11|11|11|
11|11|11|11|11|11|11|11|11|11|11|11|