Nortel DMS-100 Series Maintenance Manual page 479

SHELF SLOTS: 1| 2| 3| 4| 5| 6| 7| 8| 9| A| B| C|
A 10|11|11|11|11|11|11|11|11|11|11|11|
B 11|11|11|11|11|11|11|11|11|11|11|11|
C 11|11|11|11|11|11|11|11|11|11|11|11|
D 11|11|11|11|11|11|11|11|11|11|11|11|
Value of 0 = unequipped line, Value of 1 = equipped line
Rt config, All chnl bsy, pWrk trc, aBbt, Set ln config
Disp ln config status, disp ln config Image
cHnl aud, send Cfield msg, Line, sMsr, *
UP:SMsm> *
LTCUP>
TIme,TAsk,Load,Xprompt,CHEaptmr,DAtadump,Uspace,Debug,BPMonito
r,Swerr,C++monitor,Ipc,Verreg,Patches,Flq,Msg6x69,UArtimc,Newm
sging,NWmsgtrc,MSGTr,Chnls,CDm,DYnamic,MTc,Rcvrmon,SChnls,CSm,
DS1,CMr,UTr,OMUnsol,DIagnose,IMage,Audit,MAtediag,CAudit,PRfm,
PErcall,Bigfoot,PARaudt,CP,CNd,Trmtrc,SMsm,SMSS,LTst.
We can verify if the line is equipped or not by looking at the AB-bit
information being received from the SLC-96. Dumping the AB-bit
information for link 0 indicates that we are receiving the onhook patter for line
0 (Chnl 0) and for line 1 (Chnl 2). This would indicate that the SMS is
reporting an unequipped line that is actually installed in the SLC-96.
LTCUP> smss
A/bdata, Ddldata, Tsw, Psport, Rtstat, psW, Cmb, Mtc, aLms, *
UP:SMSS> a
Chnl blk, Image, port Map, Bits, sAn, Digit, Outg, Uneq scan, *
UP:SMSS> b 0
Chnl 00 on hook
Chnl 01 on hook
Chnl 02 on hook
Chnl 03 on hook
Chnl 04 on hook
Chnl 05 on hook
Chnl 06 on hook
Chnl 07 on hook
Chnl 08 unequiped
Chnl 09 on hook
Chnl 0A unequiped
Chnl 0B on hook
Chnl blk, Image, port Map, Bits, sAn, Digit, Outg, Uneq scan, *
Chnl 0C on hook
Chnl 0D unequipped
Chnl 0E on hook
Chnl 0F unequipped
Chnl 10 on hook
Chnl 11 on hook
Chnl 12 on hook
Chnl 13 unequipped
Chnl 14 on hook
Chnl 15 on hook
Chnl 16 on hook
Chnl 17 on hook
XPMTLC0001SMS XPM_PARTITION MICA
Appendix A --15