Nortel DMS-100 Series Maintenance Manual page 430

11-4 Advanced troubleshooting procedures
Data can appear if the SMS is at the ROM level. To display the data, use the
command string
The commands the system provides as part of the PMDEBUG user interface
to the SMS footprint tool appear in the following table.
SMS footprint commands
Command
DISPLAY DATA
DUMP DATA
QUERY STATUS
CLASS
SURVIVE
CLEAR
LOCK
UNLOCK
HELP
The standardized header for the output routines is:
<nnn>
where
297-8231-550 Standard 09.01 August 1998
DISPLAY MEMORY
CLASS
MAINTENANCE (#xx)
.
Use
Displays formatted data. If the system binds a
display routine in, the data saved is formatted.
Displays unformatted data. Data displays in
hexadecimal format (16 bytes).
This command retrieves the state of the active and
holding data areas. The SMS footprint ID area
contains the type of information provided.
Enables, disables or queries event classes. The
state (enabled/disabled) appears for the queried (or
ALL) classes.
Enables, disables or queries the ability of class
settings to maintain a restart.
This command clears the data areas to the first
states. Resets the SMS footprint ID area to the first
state.
This command locks the active or holding data area.
This command provides for field personnel and
programmers who want to save data collected. The
command activates when the tool does not lock the
buffers automatically.
This tool unlocks the active or holding data area.
Use this command if the data collected is no longer
needed. Use this command when the data display
ends.
This command provides the syntax for the preceding
commands.
EVENT CC TIME OF EVENT
#yy 01:13:19:12.52