Nortel DMS-100 Series Maintenance Manual page 476

A --12 Appendix
A/bdata, Ddldata, Tsw, Psport, Rtstat, psW, Cmb, Mtc, aLms, *
UP:SMSS> a
Chnl blk, Image, port Map, Bits, sAn, Digit, Outg, Uneq scan, *
UP:SMSS> b 0
Chnl 00
Chnl 01
Chnl 02
Chnl 03
Chnl 04
Chnl 05
Chnl 06
Chnl 07
Chnl 08
Chnl 09
Chnl 0A
Chnl 0B
Chnl blk, Image, port Map, Bits, sAn, Digit, Outg, Uneq scan, *
UP:SMSS>
If we now check to see what the SMS is looking for, we see that it is looking
for the onhook pattern to occur, in order to progress out of the unequipped
state. Remember that when the card is plugged in, it sends the onhook pattern
first.
Chnl blk, Image, port Map, Bits, sAn, Digit, Outg, Uneq scan, *
UP:SMSS> c 0 0
mode: scan onhook from unequip
timer blk not attached
Chnl blk, Image, port Map, Bits, sAn, Digit, Outg, Uneq scan, *
UP:SMSS> c 0 2
mode: scan onhook from unequip
timer blk not attached
Chnl blk, Image, port Map, Bits, sAn, Digit, Outg, Uneq scan, *
It is important to note that although CHNL 0D in the bits display on page 9 is
reporting the unequipped AB-bit patter that the SMS indicates that it is not
scanning this line at the channel block level.The Bits level reports what the
incoming AB-bits are for all 24 DS0 timeslots. Even though the SLC-96
reports appropriate AB-bit information to the SMS, the SMS does not evaluate
that information unless the line is datafilled in the DMS (has a directory
OPEN WRITING XPMTLC0001SMS.AA02 2000/04/13 11:31:50
unequiped
on hook
unequiped
on hook
on hook
on hook
on hook
on hook
unequiped
on hook
unequiped
on hook
Chnl 0C on hook
Chnl 0D unequipped
Chnl 0E on hook
Chnl 0F unequipped
Chnl 10 on hook
Chnl 11 on hook
Chnl 12 on hook
Chnl 13 unequipped
Chnl 14 on hook
Chnl 15 on hook
Chnl 16 on hook
Chnl 17 on hook
flash option: false
flash option: false