Nortel DMS-100 Series Maintenance Manual page 23

or
Use the following parameters to load the local loadfile:
WARNING
Possible service interruption
The LOCAL LOADFILE option of the LOADPM
command has a parameter of [<file> string}]. If you use
this file_name parameter, you must use the loadfile named
in the parameter. The loadfile named in the parameter is
not patched. Do not use this parameter unless you revive
the NOPATCH option of the loadfile.
>LOADPM [PM] LOCAL LOADFILE
[ACTIVE]
[INACTIVE]
[UNIT]
Note: Only peripherals that are not ISDN support the IMAGE parameter.
The XPL uses image technology to improve peripheral loading. The CM
has a high level of image control because the system monitors changes to
restart survivable objects in the XPM. Restart survivable objects are static
data and code, in the form of patches. The XPL dumps an image and copies
NTMX77 RAM in an XPM unit. The XPM unit can be in service (InSv),
active or inactive. The XPL copies the image to the NT7X05. If an XPM
reload is necessary, the system restores the image from the NT7X05 to the
UP RAM.
Note: You cannot dump an image of an embedded processor. Use the
LOADPM command with the CC CMR parameters to load the CMR
processor from the CM.
To dump images manually to the NT7X05 card, use the enhanced PM MAP
level command LOADPM. Manually dump images to the NT7X05 card
when the XPM is InSv. Use the parameters that follow:
>XPMSTOR [PM] CC [loadfile_name]
[ACTIVE]
[INACTIVE]
Note: If you enter the loadfile_name, the name must be the name of the file
entered in field LOAD in inventory table LTCINV.
DMS-100 Family SMS Maintenance Manual XPM10 and up
Maintenance overview 1-7