Usage - Olympus USPM-RU-W Series Operation Manual

3. Usage

This chapter describes the outline of software according to the general procedure. For
details on use, conduct full training from the standpoint of a specialist.
3.1.Program start and termination
Start
Double-click the USPM-SA shortcut icon on the desktop and start the software. Turn on the
power to all the hardware used and then start the software.
Termination
Select [File] - [Quit] from the file menu and terminate the software. Then, turn off the power
to all hardware.
3.2.Measurement of spectral measured values (spectral reflection factors and spectral
transmission factors)
Various operation buttons are arranged on the main window. These operation buttons
enable the spectral measured values to be measured. Measure these using the procedure
below to obtain the spectral measured values of the sample to be measured.
Setting the work setting file
Select [Setup] - [Work] from the file menu and open a WORK setting window. Set each item
according to the sample to be measured. For details on the settings, see the [6.2 Work
setting].
PV8959-F4E005 8