How To Use - Olympus USPM-RU-W Series Operation Manual

4. How to Use

This chapter describes the general operations of the unit. For details on the usage, all
personnel operating the unit should be sufficiently trained from the viewpoint of each
specialized area.
4.1. A flow of measurement
[In micro-spectrophotometry]
(1) Turn on the controller supply unit, and then start the computer and open the software
application.
Refer to 4.2 Launch.
(2) Choose an objective lens.
Refer to 4.3 Choosing an objective lens.
(3) Choose the ring slit
Refer to 4.4 Choosing the ring slit.
(4) Set up the work configuration file.
Refer to 4.5 Setup of the work configuration file.
(5) Put the BK7 reference sample.
Refer to 4.6 Setting the BK7 reference sample
/Setting the sample to be measured
(6) Adjust the position of the BK7 reference sample.
Refer to4.6 Setting the BK7 reference sample
/Setting the sample to be measured
(7) Adjust the sampling interval.
Refer to 4.8 Adjusting the sampling interval.
(8) Obtain the background value.
Refer to 4.9 Obtaining the background value.
(9) Obtain the reference value.
Refer to 4.10 Obtaining the reference value.
(10) Set the sample to be measured.
Refer to 4.6 Setting the BK7 reference sample
/Setting the sample to be measured
(11) Adjust the position of the sample.
Refer to 4.6 Setting the BK7 reference sample
/Setting the sample to be measured
PV8344F4E013
When the computer is misbehaving or any failure is found
in the measurement data, plug off and reinsert USB cable
and then reboot the software.
If you still have such troubles after rebooting the software,
please turn off the Control Power Supply Box and then
reboot the computer.
Even if you still have such trouble after rebooting the
computer, please contact to us.
26