Olympus USPM-RU-W Series Operation Manual page 10

Do not place the unit in an unstable location!
If the unit is placed on an unstable stand, on an incline, or on a rigid floor, it
may be knocked over or fall down, resulting in injury.
Fully check the strength and incline of the installation location.
Do not attempt to replace a lamp just after turning it off!
The lamp is hot just after the light is turned off. Wait until the lamp cools
before replacing it. Otherwise there is a risk of burns.
Pay attention when adjusting focus!
In adjusting focus, pay close attention to the location of the objective lens so
that it does not touch a sample.
Measure a room-temperature sample!
Measure a room-temperature sample. A high-temperature sample may
cause heat deformation of or damage to the stage.
PV8344F4E013
Failure to follow these precautions may result in injury or material
damage to this Product or peripheral devices.
8