Olympus USPM-RU-W Series Operation Manual page 18

2.2.
The names and functions of the items on the controller supply unit
1. Power switch
2. Power indicator
4. Lamp 1 connector
Lamp 2 connector
5. IO connector
The functions and operating methods are shown below:
1. Power switch
Turn on or off the power of the controller supply unit.
2. Power indicator
Light on when power is on and off when power is off.
3. Lamp 1 switch / Lamp 2 switch
Supplies power to the lamp house or switches the power destination. Turning on a
switch supplies power through the corresponding connector (Lamp 1 or Lamp 2
connector) to illuminate the halogen lamp.
4. Lamp 1 connector / Lamp 2 connector
Each connector supplies power to the corresponding lamp house.
Connect a LAMP cable to each connector. (DC 12V
5. IO connector
Supplies control voltage to the unit. Connect an IO cable. (DC 12V
Always use the supplied cable.
With any other cables, there is a risk of malfunction due to internal or external
noise. The supplied cables may not be used for any other devices.
6. Power inlet
Connect the power cord here to supply power to the controller supply unit. The
component is equipped with a fuse. For details on replacing the fuse, refer to 3.4
Installation and replacement of fuses.
PV8344F4E013
Front view of the controller supply unit
Rear view of the controller supply unit
Lamp 2 switch and connector are used with an optional unit
(Transmittance measurement set, 45-degree measurement set).
16
3. Lamp 1 switch
Lamp 2 switch
6. Power inlet
)
)