Olympus USPM-RU-W Series Operation Manual page 27

3.7. Connection
Connect the cables according to the figure below:
LAMP
IO
Item
1 Lamp cable
2 IO cable
3 USB cables
(two)
4 Power cord
5 Protection key
PV8344F4E013
Take care not to apply excessive force in handling the cables, since
they can be damaged by bending or twisting.
For cable setting, keep cables away from something sharp.
Connect the cables only when all power switches are turned off and
the power cord is unplugged.
There is the possibility of melting the power cord and creating a
short-circuit if the power cord comes into contact with the lamp
house. Leave enough space between the power cord and the lamp
house.
Always use the supplied cables. Using any other cables than the
supplied may cause failures due to internal and/or external noises.
The supplied cables are not suitable for use with any other device.
1. Lamp cable
USB 1
USB 2
3. USB cable
5. Protection key
3. USB cable
Between "LAMP" connector on the unit and "LAMP 1" connector on the
controller supply unit
Between "IO" connector on the unit and "IO" on the controller supply unit
Between "USB 1" / "USB 2" on the unit and any two USB ports on the
computer (no distinction between cables and ports)
Plug into a 100–240 V power supply. Use the supplied power cord; insert it
into a standard two-blade electric outlet with ground terminal. Without
grounding, the intended electrical safety is not achieved.
Any USB port on the computer
2. IO cable
LAMP 1
IO
Connection
25
4. Power cord
PC