Others - Olympus USPM-RU-W Series Operation Manual

8. Others

8.1.Loading the setting files using a shortcut
By setting the property of a shortcut, the specified setting file can be loaded when software is
started using a shortcut. The way in which you can specify a setting file is described below.
(1) Create a shortcut for this software on the desktop and open the property of the created
shortcut. The executable file of this software exists in [C: ¥USPM-SA¥uspm.exe].
(2) Select the [Shortcut] tab from Properties. Enter the parameter arguments and their
corresponding setting values in the [Link destination] field. Put one half-size space
between the parameter arguments and setting values during entry. The parameter
arguments and their corresponding setting values are shown in the table below. The
extensions of the setting values can be omitted. Various setting files loaded as the setting
values must be stored in the specified file arrangement destination.
Parameter
argument
-R
-G
-L
-Y
-T
PV8959-F4E005
Setting value
Work setting filename (*.ref)
Graph setting filename (*.grph)
Layout filename (*.layout)
Layer setting filename (*.lay)
Subtitle
Example: The case is given where a work setting file
File arrangement destination
[C:¥USPM-SA¥Param] folder
[C:¥USPM-SA¥Param] folder
[C:¥USPM-SA¥Conf] folder
[C:¥USPM-SA¥Param] folder
-
"example.ref" is loaded during startup.
Add "-R example" after
"C:¥USPM-SA¥uspm.exe" in the "Link
destination" field.
"C:¥USPM-SA¥uspm.exe -R example" is
obtained as a whole. (" " indicates a half-size
space.)
53